Citroën Xantia

since 1993 release

Repair and operation of the car



Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
- Body and finishing of salon
   Care of components of a body and bottom of the car
   Care of an upholstery and carpets of salon
   Repair of insignificant damages of body panels
   Repair of seriously damaged body panels
   Removal and installation of a front bumper
   Removal and installation of a rear bumper
   Removal, installation and adjustment of a cowl
   Removal and installation of a driving cable of an otpuskaniye of the lock of a cowl
   Removal and installation of locks of a cowl
   Removal, installation and adjustment of doors
   Removal and installation of panels of an internal upholstery of doors
   Removal and installation of door handles and components of the lock
   Removal and installation of regulators of window regulators of door windows
   Removal, installation and adjustment of a door of a back and its telescopic emphasis
   Removal and installation of components of the lock of a door of a back
   Removal and installation of components of the uniform lock
   Removal and installation of components of the electric drive of door window regulators
   Removal and installation of door rear-view mirrors and the accompanying components
   Windshield, glass of a door of a back and the other fixed glasses - the general information
   The top hatch - the general information
   Exterior body finish
   Removal and installation of seats
   Removal and installation of seat belts
   Removal and installation of elements of internal finishing of salon
   Removal and installation of the central console
   Removal and installation of the dashboard
   Control body sizes
+ Onboard electric equipment
+ Schemes of electric equipment


04d84ca1



Removal and installation of locks of a cowl

Removal

 PERFORMANCE ORDER

1. Remove a front grille (see. Exterior body finish).
2. Mark position of the lock concerning the front panel.

3. At removal of the right castle assembly turn out two fixing bolts and take the lock from the front panel. After extraction from the panel disconnect an executive rod of the lock and (at the corresponding complete set) release the sensor switch of the anticreeping alarm system.
A — Fixing bolts
In — the Sensor switch of the anticreeping alarm system

4. On the left lock turn out two fixing bolts and disconnect the executive lever and a driving cable.

Installation

Installation is made upside-down. Track combination of the landing tags put in the course of dismantle. Before establishing a front grille, check serviceability of operation of latches. In case of need weaken fixing bolts and adjust the provision of the corresponding assembly, trying to obtain adequate functioning of the lock.


On the homepage