Citroën Xantia

since 1993 release

Repair and operation of the car


Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
- Body and finishing of salon
   Care of components of a body and bottom of the car
   Care of an upholstery and carpets of salon
   Repair of insignificant damages of body panels
   Repair of seriously damaged body panels
   Removal and installation of a front bumper
   Removal and installation of a rear bumper
   Removal, installation and adjustment of a cowl
   Removal and installation of a driving cable of an otpuskaniye of the lock of a cowl
   Removal and installation of locks of a cowl
   Removal, installation and adjustment of doors
   Removal and installation of panels of an internal upholstery of doors
   Removal and installation of door handles and components of the lock
   Removal and installation of regulators of window regulators of door windows
   Removal, installation and adjustment of a door of a back and its telescopic emphasis
   Removal and installation of components of the lock of a door of a back
   Removal and installation of components of the uniform lock
   Removal and installation of components of the electric drive of door window regulators
   Removal and installation of door rear-view mirrors and the accompanying components
   Windshield, glass of a door of a back and the other fixed glasses - the general information
   The top hatch - the general information
   Exterior body finish
   Removal and installation of seats
   Removal and installation of seat belts
   Removal and installation of elements of internal finishing of salon
   Removal and installation of the central console
   Removal and installation of the dashboard
   Control body sizes
+ Onboard electric equipment
+ Schemes of electric equipment

04d84ca1


Removal and installation of elements of internal finishing of salon

Casings of a steering column

Removal

 PERFORMANCE ORDER

1. Remove steering wheels (address the Head the Running gear and steering).

2. Turn out two screws under a steering column and remove the top casing of the last.

3. Turn out the right screw of fastening of the lower casing to a ledge on assembly of a column.

4. Remove the lower casing from a column, then release from it a rheostat of management of intensity of illumination of the dashboard and disconnect an electrical wiring. Remove a casing.

Installation

Installation is made upside-down.

Panels of an internal upholstery of doors

See Removal and installation of panels of an internal upholstery of doors.

Panels of internal finishing of salon and luggage compartment

For fastening of panels screws and various type clamps are used. The order of removal of panels is usually quite obvious.

Carpet

For facing of a floor two sections of a carpet are used. Sections fasten to floor panels by means of screws or clamps. Usually the same fixture is used for fixing of the interfaced panels of finishing of walls of salon.

Removal of a carpet is not connected with any special difficulties, however, it is accompanied by considerable time expenditure as demands preliminary removal of seats, the central console, anchor knots of seat belts and the interfaced vertical panels of finishing.

Ceiling upholstery

The ceiling upholstery fastens to a car roof by means of clamps. For removal of a ceiling upholstery it is necessary to dismantle previously such elements of the equipment of salon as poruchnevy handles, sun-protection peaks, various finishing panels, and also sealing strips of doorways and an aperture of the top hatch.

It is necessary to notice that dismantle of a ceiling upholstery demands from the performer of certain skills and it is connected with risk of damage of obivochny material, and therefore, its performance will be reasonable to charge to specialists of car service.


On the homepage