Removal and installation of components of the uniform lock
Electronic control unit Removal The block is located under the central console.
Installation
Installation is made upside-down.
Door activators
Activators of the uniform lock are built in castle assemblies of doors (see Removal and installation of door handles and components of the lock).
Back door lock activator
|
|
|
1. Disconnect a negative wire from the battery.
2. Open a back door.
3. Open hatches of access and disconnect an electrical wiring from the combined lamps which are built in a door back.
4. Release clamps, turn out fixing screws and remove the panel of the lower finishing of a door of a back. |
|
5. Turn out two fixing bolts. |
|
|
6. Take the activator of the door lock, then disconnect from it an electrical wiring. |
|
|
7. Installation is made upside-down. |
|
The receiver of signals from the remote control
|
|
|
1. Having accurately hooked, remove the panel of a cover of an electric motor of the drive of the top hatch. |
|
|
2. Release clamps and remove the receiver of signals of the DU panel of the uniform lock from the cover panel, disconnect an electrical wiring. |
|
|
3. Installation is made upside-down. |
|
DU panel batteries
|
|
|
1. Turn out the small self-cut screw in a back part of assembly of the transmitter. Extend the transmitter from a back cover for the purpose of ensuring access to batteries.
2. Take batteries (try to remember their correct adjusting situation).
3. Install by the correct image two new batteries, establish into place a cover and tighten the self-tapping screw. |
|
|
