Citroën Xantia

since 1993 release

Repair and operation of the car



Citroën Xantia
+ Introduction
+ Operation manual
- Routine maintenance
   + Weekly checks
   + Routine maintenance of the car - petrol models
   + Routine maintenance of the car - diesel models
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and finishing of salon
+ Onboard electric equipment
+ Schemes of electric equipment


04d84ca1



Routine maintenance

Specifications

Mass-dimensional characteristics

All specified parameters have approximate value and can change depending on model.

Dimensions
(values for the Station wagon models are given in brackets)

Total length, mm

4520 (4710)

Full width, mm

1760 (1760)

Full height of not loaded car, mm


1400 (1420)

Wheel base, mm

2740 (2740)

Weight

Net weight, kg

1176 ÷ 1260 *

Maximum admissible weight gross, kg

1480 ÷ 1655 *

Maximum permissible load
on the top luggage carrier, kg

75

Maximum allowable weight of the trailer, kg

1200

* Depending on model.

Pressure of a rating of tires (in a cold state)

Tire type

Forward wheels, bar

Back wheels, bar

175/70 R 14 84T

2.3

2.1

175/70 R 14 84H

2.3

2.1

185/65 R 14 86H

2.3

2.1

195/55 R 14 84V

2.4

2.2

165/70 R 14 81T (spare wheel) *

2.9

2.9

185/65 R 14 87T (spare wheel) *

2.5

2.5

Pressure of a rating of tires is given also in Schild, the driver's door fixed on the rear edge the values Given below belong to tires of a basic equipment and can differ from the required parameters set on the concrete car of wheels. Consult in a tire workshop. Usually nominal pressure of a rating of the tire is specified on its side surface.
* Speed of the movement of the car with the established spare wheel should not exceed 113 km/h (75 miles/h)

Types of lubricants and liquids

Engines

Universal engine oil viscosity of SAE 10W/40 or 15W/50, API SG/CD

Cooling system

Antifreeze on the basis of ethylene glycol with soft water

RKPP

Gearbox oil, Shell SF5288 75/80W

AT

ATF Dexron II

Hydraulic system

Mineral hydraulic LHM liquid

Volumes of working liquids

Motive oil

l

Petrol models

   - Without oil filter

      • L models 1.6 and 1.8

4.5

      • Models of 2.0 l

         a) Stamped pallet of a case

4.6

         b) Aluminum pallet

4.2

   - Including an oil filter, l

      • L models 1.6 and 1.8

4.8

      • Models of 2.0 l

 

         a) Stamped pallet of a case

5.0

         b) Aluminum pallet

4.6

The amount of oil necessary for rise in its level from the mark MIN to mark MOVE of the measuring probe

1.5

Diesel models

 

   - Without oil filter

4.8

   - Including an oil filter

5.1

The amount of oil necessary for rise in its level from the mark MIN to mark MOVE of the measuring probe

1.0

Liquid of cooling of the engine

l

Petrol models

   - L models 1.6 and 1.8

 

      • Models without conditioner
air (K/V)

7.0 (approximately)

      • Models with To/in

8.0 (approximately)

   - Models of 2.0 l

8.3 (approximately)

Diesel models

 

   - Models without turbo-supercharging and To/in

7.5 (approximately)

   - Models without turbo-supercharging and with To/in

8.5 (approximately)

   - Models with a turbo-supercharging

9.0 (approximately)

Gearbox oil

l

Manual Box of Gear Shifting (MBGS)

1.9

Automatic Transmission (AT)

   - Sukhoi case

6.2

   - Liquid replacement

2.4

Hydraulic LHM liquid

l

All models

5.4

Volume of the fuel tank

l

All models

65


Engine

Oil filter

Champion F104

Tension of a driving belt of auxiliary units (it is made by means of the special Citroyon tool)

60 SEEM blocks

Cooling system

Petrol models

Composition of cooling liquid *

   - 28% of antifreeze

Frost resistance to -15 °C

   - 50% of antifreeze

Frost resistance to -30 °C

* See also instructions of manufacturers of antifreeze.

Power supply system

Characteristic

Value

Petrol models

Idling turns (mines-1)

850 ± 50 (to adjustment are not subject,
ECU are controlled)

The maximum admissible
concentration WITH in the fulfilled gases
at idling mix

0.4% (to adjustment is not subject,
ECU is controlled)

For more details see appropriate section of the Head of the Power supply system and release.

The filtering air cleaner element

Champion U615

Fuel filter

Champion L206

Diesel models

Idling turns (mines-1)

 

   - Models without To/in

800 +0, 800 - 50

   - Models with To/in

850

Turns of prevention of a spontaneous stop of the engine (mines-1)

1500 ± 100

Thickness of an adjusting washer of installation of turns of prevention of a stop, mm

 

   - Lucas

4.0

   - Bosch

3.0

Turns of bystry idling (mines-1)

950 ± 50

The filtering air cleaner element

Champion U543

Fuel filter

Champion L141

Type of candles of an incandescence

Champion CH68

System of ignition

Type of spark plugs

   - L models 1.6 and 1.8

Champion RC9YCC

   - Models of 2.0 l

Champion RC7YCC

Size of an interelectrode gap, mm

0.8

* The size of an interelectrode gap is specified proceeding from requirements imposed by Champion. At installation of candles of other producers adhere to recommendations of the last.

Brake mechanisms

Minimum admissible thickness
frictional slips

mm

Blocks of forward brake mechanisms

3.0

Blocks of back brake mechanisms

2.0


Efforts of tightening of threaded connections

Nanometer

Bolts of fastening of an assembly bracket of a natyazhitel
driving belt of auxiliary units

22

Bolts of fastening of wheels

90

Spark plugs

25

Stopper of a jellied/control opening
transmission case

20

Stopper of a drain opening of transmission

30



On the homepage