Citroën Xantia

1. Lower a windowpane on two thirds of its course, then remove the panel of an internal upholstery and the sealing screen of a door (see Removal and installation of panels of an internal upholstery of doors).

2. From the inside of a door release a plastic clamp of fastening of a windowpane to the regulator: for what develop a clamp on 45 °, remove it, then release glass from the regulator mechanism.

3. Remove a sealing strip from bottom edge of a window opening.

4. Ask the assistant and to take glass him in the lifted situation, or lift glass and fix it by an adhesive tape.

5. In a forward part of a door give a nut of fastening of the forward directing glass runner. Take a runner through an opening in a doorframe.

6. Remove a sealing strip from the rear edge of a window opening and extract glass from a door.

1. Freely fill the forward directing runner on the regular place, then lower glass at a door and fix it on the regulator by a plastic clamp, having tracked reliability of a zashchelkivaniye of the last.
2. Correct the provision of the directing runner and fix it by a nut.

3. Establish a sealing strip on the rear edge of a window opening, having tracked that the directing ledge on the rear edge of glass got to the trench of a rubber strip. Make sure of density of landing of a sealing strip.

4. Put a sealing strip from within on bottom edge of a window opening.
5. Install on a door the plastic sealing screen and the panel of an internal upholstery (see Removal and installation of panels of an internal upholstery of doors).

1. Completely lift a windowpane, then remove the panel of an internal upholstery and the plastic sealing screen of a door (see Removal and installation of panels of an internal upholstery of doors).

2. In the bottom back corner of a door turn out the screw of fastening of directing windowpane trench.

3. Then take a trench through an opening at doors.

4. Completely lower glass, develop under 45 ° and remove a plastic clamp, then release glass from the regulator mechanism.
5. Remove a sealing strip from bottom edge of a window opening.
6. Remove a sealing strip from the rear edge of a window opening and extract glass from a door.

1. Freely fill the back directing trench on the regular place, then lower glass at a door and fix it by a plastic clamp on the window regulator regulator. Track reliability of a zashchelkivaniye of a clamp.
2. Correct the provision of the directing trench so that its upper edge was included into gearing with a uvula in the top part of a door, then screw and tighten the fixing screw.
3. Put a sealing strip on the rear edge of a window opening (track hit in a groove of a strip of directing glass ledge). Make sure of density of landing of a strip.
4. Put a sealing strip from within on bottom edge of a window opening.
5. Install the plastic sealing screen and the panel of an internal upholstery of a door (see Removal and installation of panels of an internal upholstery of doors).

1. Lower door glass on two thirds of its course, then remove the panel of an internal upholstery and the plastic sealing screen of a door (see Removal and installation of panels of an internal upholstery of doors).
2. From the inside of a door release a plastic clamp of fastening of glass to the window regulator regulator: turn under 45 ° and remove a clamp, then release glass from the regulator mechanism.
3. Lift glass in the top situation and fix it by an adhesive tape. Make sure of reliability of fastening of glass.
4. Through an opening in a doorframe disconnect an electrical wiring from a window regulator drive electric motor.

5. Give three nuts of fastening of assembly of an electric motor, then two more which the directing glass runner fastens.

A — three nuts of fastening of assembly of an electric motor of the drive of a window regulator
In — two nuts of fastening of the directing runner

6. Take assembly through an opening at doors.