Citroën Xantia

since 1993 release

Repair and operation of the car



Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
- Body and finishing of salon
   Care of components of a body and bottom of the car
   Care of an upholstery and carpets of salon
   Repair of insignificant damages of body panels
   Repair of seriously damaged body panels
   Removal and installation of a front bumper
   Removal and installation of a rear bumper
   Removal, installation and adjustment of a cowl
   Removal and installation of a driving cable of an otpuskaniye of the lock of a cowl
   Removal and installation of locks of a cowl
   Removal, installation and adjustment of doors
   Removal and installation of panels of an internal upholstery of doors
   Removal and installation of door handles and components of the lock
   Removal and installation of regulators of window regulators of door windows
   Removal, installation and adjustment of a door of a back and its telescopic emphasis
   Removal and installation of components of the lock of a door of a back
   Removal and installation of components of the uniform lock
   Removal and installation of components of the electric drive of door window regulators
   Removal and installation of door rear-view mirrors and the accompanying components
   Windshield, glass of a door of a back and the other fixed glasses - the general information
   The top hatch - the general information
   Exterior body finish
   Removal and installation of seats
   Removal and installation of seat belts
   Removal and installation of elements of internal finishing of salon
   Removal and installation of the central console
   Removal and installation of the dashboard
   Control body sizes
+ Onboard electric equipment
+ Schemes of electric equipment


e94432e4



Removal and installation of a front bumper

Removal

 PERFORMANCE ORDER

1. Having hooked, take fastening clamps to a bumper of panels of protection of wings (loker).

2. Having hooked, uncover access in loker of arches of forward wheels.

3. Working through the opened openings, give bolts of fastening of a bumper.

4. Through arches of wheels turn out side screws of fastening of a bumper to wings.

5. From under the car turn out three lower screws of fastening of a bumper.

6. At the corresponding complete set remove forward fog lights (address the Head Onboard electric equipment).

7. Through openings under installation of fog lights turn out back bolts of fastening of a front bumper (on one from each party).

8. Delay a bumper forward.

9. On models with the corresponding complete set do not forget to disunite contact sockets of an electrical wiring of fog lights.

Installation

Installation is made upside-down. At the corresponding complete set do not forget to connect an electrical wiring to fog lights.

On the homepage