Citroën Xantia

since 1993 release

Repair and operation of the car



Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
- Body and finishing of salon
   Care of components of a body and bottom of the car
   Care of an upholstery and carpets of salon
   Repair of insignificant damages of body panels
   Repair of seriously damaged body panels
   Removal and installation of a front bumper
   Removal and installation of a rear bumper
   Removal, installation and adjustment of a cowl
   Removal and installation of a driving cable of an otpuskaniye of the lock of a cowl
   Removal and installation of locks of a cowl
   Removal, installation and adjustment of doors
   Removal and installation of panels of an internal upholstery of doors
   Removal and installation of door handles and components of the lock
   Removal and installation of regulators of window regulators of door windows
   Removal, installation and adjustment of a door of a back and its telescopic emphasis
   Removal and installation of components of the lock of a door of a back
   Removal and installation of components of the uniform lock
   Removal and installation of components of the electric drive of door window regulators
   Removal and installation of door rear-view mirrors and the accompanying components
   Windshield, glass of a door of a back and the other fixed glasses - the general information
   The top hatch - the general information
   Exterior body finish
   Removal and installation of seats
   Removal and installation of seat belts
   Removal and installation of elements of internal finishing of salon
   Removal and installation of the central console
   Removal and installation of the dashboard
   Control body sizes
+ Onboard electric equipment
+ Schemes of electric equipment


e94432e4



Exterior body finish

Decorative front grille

Removal

 PERFORMANCE ORDER

1. Remove assemblies of forward indexes of turns (address the Head Onboard electric equipment).

2. Turn out two lower screws of fastening of a front grille (are located under indexes of turns).

3. Turn out two top screw or a clamp.



4. At the corresponding complete set turn out two forward fixing screws (through openings from the forward party of the panel of a lattice) and remove a lattice.

Installation

Installation is made upside-down.

Protection of the bottom and wheel arches

 PERFORMANCE ORDER

1. For protection of the lower surfaces of a body and a frame of the car various plastic boards and screens are used. Fastening of protective elements is carried out by means of screws and clamps which usually easily come to light at external survey of panels. Moving along the panel of a protective element, methodically turn out/release all fixture then the panel has to be removed freely. Remember that some fixing clamps have a two-component design. To remove such clamp it is necessary to take at first from it the central pin then the main part of the case with lock hooks is already taken out. On some models protective panels fasten by means of rivets which should be drilled.



2. At assembly replace the plastic clamps which failed during dismantle and track reliability of fixing of the panel. Rivets are subject to replacement by definition.

Decorative strips and emblems

For fastening of this sort of finishing components the special sticky structure which is softened when heating is used. The element gets warm previously by means of the hair dryer, then the glue layer is knifed by thin. In view of high risk of damage of a paint and varnish covering when cutting of the softened glue layer, removal of elements of decorative finishing will be most correct to be charged to specialists of car service.

On the homepage