Citroën Xantia

since 1993 release

Repair and operation of the car



Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and finishing of salon
- Onboard electric equipment
   Search of causes of failures of electric equipment
   Safety locks and the relay - the general information
   Removal and installation of switches
   Replacement of lamps of external lighting and alarm fixtures
   Replacement of lamps of internal lighting fixtures
   Removal and installation of external lighting and alarm fixtures
   Adjustment of optical axes of head headlights
   Removal and installation of an instrument guard
   Removal and installation of components of an instrument guard
   Removal and installation of hours
   Removal and installation of the lighter
   The alarm system "do not forget to switch off lighting fixtures" - the general information
   Removal and installation of a horn of a horn
   Removal and installation of a driving cable of the speedometer/sensor of speed
   Removal and installation of the lever of a screen wiper
   Removal and installation of an electric motor and drafts of the drive of screenwash
   Removal and installation of an electric motor of the drive of a back screen wiper
   Removal and installation of components of system of washing of glasses and lenses of head block headlights
   Removal and installation of the radio tape recorder
   Removal and installation of loudspeakers
   Removal and installation of the antenna of the radio receiver
   Anticreeping system - the general information
   Safety cushion - the general information, precautionary measures and deactivation of system
   Removal and installation of components of a safety cushion
   Diagnostics of systems of electronic control
+ Schemes of electric equipment


e94432e4



Removal and installation of components of an instrument guard

 PERFORMANCE ORDER

1. Remove an instrument guard (see Removal and installation of an instrument guard).

Measuring instruments

 PERFORMANCE ORDER

1. Extend the button of dumping of the counter of the current distance in kilometers from a forward part of an instrument guard.
2. Release fixing clamps, turn out screws and remove assembly of the panel of facing of an instrument guard with protective glass.

3. Access to all measuring instruments, except a speedometer is provided by removal of a back cover of a combination of devices (give fixing screws).
A — the Back cover of a combination of devices
B — Screws of fastening of assembly of a speedometer

4. Give fixing screws or nuts and remove the corresponding measuring instrument. Pay attention that fastening of some measuring instruments is carried out by means of clamps of its contact sockets.

5. Installation is made upside-down.

Control lamps and lamps of illumination of devices

 PERFORMANCE ORDER

1. Turn a cartridge of the failed lamp counterclockwise and take it from assembly of a combination of devices. Lamps are replaced assembled with cartridges.


On the homepage