Removal and installation of a driving cable of the speedometer/sensor of speed
|
|
Some of models are equipped with a speedometer of electronic type with the speed sensor installed on the transmission which replaces with itself(himself) the hummock drive used in system of mechanical type. |
Hummock drive Removal
|
|
|
1. In a motive compartment take a pin of fastening of a driving cable on a transmission case. Disconnect a cable tip from transmission.
2. Sharply extend a driving cable for the purpose of release of its spherical tip from the directing plug in a partition of a motive compartment.
3. Involve a cable in a motive compartment and remove it from the car. Try to remember a route of laying of a cable and location of its intermediate guides of clamps. |
|
Installation
Installation is made upside-down. Before landing grease a sharovy tip of a cable with soap solution. Track correctness of laying of a cable and its landing in the plug through passage in a partition.
Speed sensor
Removal
|
|
|
1. It is the simplest to approach the sensor from under the car. For the purpose of simplification of access prop up antiretractable boots back wheels, then a front of the car and establish to a poddomkratta it on props.
2. Disunite the contact socket of an electrical wiring of the sensor of speed.
3. Turn out a fixing bolt and remove the sensor together with the thermofilter. |
|
Installation Installation is made upside-down. Make sure of serviceability of a condition of a sealing ring in the sensor basis, in case of need make its replacement. At the corresponding complete set do not forget to install into place the sensor thermofilter.
|
