|
1. Disconnect a negative wire from the battery.
2. Before a detachment of the battery make sure that the brush of a screen wiper holds parking position.
3. Remove the screen wiper lever (see Removal and installation of the lever of a screen wiper). |
|
4. Turn out fixing screws / release the clamps located on both sides of a protective cover of the drive of a screen wiper. |
|
|
5. Accurately cut with a fine edge the sealant located between the panel of a cover of the drive and a surface of a windshield.
|
|
6. At the corresponding complete set uncover the isolating sensor switch of the anticreeping alarm system with a sealing ring. |
|
|
7. Take the sensor switch from a cover of the drive of screen wipers. Remove the cover panel. |
|
|
8. Turn out six fixing bolts and release assembly of an electric motor with driving drafts. |
|
|
9. Disconnect an electrical wiring and remove driving assembly from the car. |
