Citroën Xantia

since 1993 release

Repair and operation of the car



Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and finishing of salon
- Onboard electric equipment
   Search of causes of failures of electric equipment
   Safety locks and the relay - the general information
   Removal and installation of switches
   Replacement of lamps of external lighting and alarm fixtures
   Replacement of lamps of internal lighting fixtures
   Removal and installation of external lighting and alarm fixtures
   Adjustment of optical axes of head headlights
   Removal and installation of an instrument guard
   Removal and installation of components of an instrument guard
   Removal and installation of hours
   Removal and installation of the lighter
   The alarm system "do not forget to switch off lighting fixtures" - the general information
   Removal and installation of a horn of a horn
   Removal and installation of a driving cable of the speedometer/sensor of speed
   Removal and installation of the lever of a screen wiper
   Removal and installation of an electric motor and drafts of the drive of screenwash
   Removal and installation of an electric motor of the drive of a back screen wiper
   Removal and installation of components of system of washing of glasses and lenses of head block headlights
   Removal and installation of the radio tape recorder
   Removal and installation of loudspeakers
   Removal and installation of the antenna of the radio receiver
   Anticreeping system - the general information
   Safety cushion - the general information, precautionary measures and deactivation of system
   Removal and installation of components of a safety cushion
   Diagnostics of systems of electronic control
+ Schemes of electric equipment


e94432e4



Removal and installation of an instrument guard

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Remove a steering wheel (address the Head the Running gear and steering).
3. Remove casings of a steering column (address the Head Kuzov and finishing of salon).
4. Open a cover of the assembly block of safety locks for the purpose of ensuring access to the screw of fastening of side angular finishing section from the driver's party of the dashboard.
5. Turn out the top and lower screws of fastening of the angular finishing panel, pull the panel on yourself and disconnect an electrical wiring of switches. Try to remember an order of connection of contact sockets. Remove the panel.

6. Turn out three screws / release clamps of fastening of the finishing panel of switches located under an instrument guard. Release the left edge of the panel from "Torpedo", then pull assembly on yourself and disconnect an electrical wiring from switches. Try to remember an order of connection of contact sockets. Remove the panel.

7. Turn out two lower fixing screws and one top, then pull an instrument guard on yourself and disconnect an electrical wiring of a combination of devices.





Installation

Installation is made upside-down. The description of the procedure of landing to the regular place of a steering wheel is provided in the Head the Running gear and steering.

On the homepage