Citroën Xantia

since 1993 release

Repair and operation of the car



Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and finishing of salon
- Onboard electric equipment
   Search of causes of failures of electric equipment
   Safety locks and the relay - the general information
   Removal and installation of switches
   Replacement of lamps of external lighting and alarm fixtures
   Replacement of lamps of internal lighting fixtures
   Removal and installation of external lighting and alarm fixtures
   Adjustment of optical axes of head headlights
   Removal and installation of an instrument guard
   Removal and installation of components of an instrument guard
   Removal and installation of hours
   Removal and installation of the lighter
   The alarm system "do not forget to switch off lighting fixtures" - the general information
   Removal and installation of a horn of a horn
   Removal and installation of a driving cable of the speedometer/sensor of speed
   Removal and installation of the lever of a screen wiper
   Removal and installation of an electric motor and drafts of the drive of screenwash
   Removal and installation of an electric motor of the drive of a back screen wiper
   Removal and installation of components of system of washing of glasses and lenses of head block headlights
   Removal and installation of the radio tape recorder
   Removal and installation of loudspeakers
   Removal and installation of the antenna of the radio receiver
   Anticreeping system - the general information
   Safety cushion - the general information, precautionary measures and deactivation of system
   Removal and installation of components of a safety cushion
   Diagnostics of systems of electronic control
+ Schemes of electric equipment


e94432e4



Adjustment of optical axes of head headlights

Exact adjustment of optical axes of head block headlights is made by means of the special equipment in the conditions of a workshop of car service.

Approximate control is made by rotation by a prutkovy key of the adjusting screws located on the upper edge of each of block headlights.

 PERFORMANCE ORDER

1. Open a cowl and make necessary adjustment, rotating the corresponding adjusting screw through a front panel opening (pay attention that it is simpler to approach the external screw from the back party of a block headlight if rather long prutkovy key is not had near at hand). The external screw serves for updating of the provision of a block headlight in the horizontal plane, internal - in vertical.
A — Screws of adjustment of horizontal position of a block headlight
B — Screws of adjustment of vertical position of a block headlight


 

On the homepage