Citroën Xantia

since 1993 release

Repair and operation of the car



Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and finishing of salon
- Onboard electric equipment
   Search of causes of failures of electric equipment
   Safety locks and the relay - the general information
   Removal and installation of switches
   Replacement of lamps of external lighting and alarm fixtures
   Replacement of lamps of internal lighting fixtures
   Removal and installation of external lighting and alarm fixtures
   Adjustment of optical axes of head headlights
   Removal and installation of an instrument guard
   Removal and installation of components of an instrument guard
   Removal and installation of hours
   Removal and installation of the lighter
   The alarm system "do not forget to switch off lighting fixtures" - the general information
   Removal and installation of a horn of a horn
   Removal and installation of a driving cable of the speedometer/sensor of speed
   Removal and installation of the lever of a screen wiper
   Removal and installation of an electric motor and drafts of the drive of screenwash
   Removal and installation of an electric motor of the drive of a back screen wiper
   Removal and installation of components of system of washing of glasses and lenses of head block headlights
   Removal and installation of the radio tape recorder
   Removal and installation of loudspeakers
   Removal and installation of the antenna of the radio receiver
   Anticreeping system - the general information
   Safety cushion - the general information, precautionary measures and deactivation of system
   Removal and installation of components of a safety cushion
   Diagnostics of systems of electronic control
+ Schemes of electric equipment


e94432e4



Removal and installation of loudspeakers

The loudspeakers installed on dashboards

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

2. Having hooked the small screw-driver, accurately take the loudspeaker panel from the top part of "Torpedo".

3. Disunite the contact socket of an electrical wiring and remove a loudspeaker.
4. Installation is made upside-down.

Door loudspeakers

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

2. Having hooked the small screw-driver, remove the loudspeaker cover panel from a door.

3. Turn out four fixing screws and remove a loudspeaker from a door, having disconnected from it an electrical wiring.

4. Installation is made upside-down.


On the homepage