|
1. Disconnect a negative wire from the battery.
2. Remove casings of a steering column (address the Head Kuzov and finishing of salon).
3. Open a cover of the assembly block for the purpose of ensuring access to the screw of fastening of the angular panel of finishing "Torpedo" from the driver's party of the car. |
|
4. Turn out the top and lower fixing screws, delay the panel forward and disconnect from it an electrical wiring. Try to remember an order of connection of contact sockets. Remove the panel. |
|
|
5. Turn out three screws / release clamps of fastening of the panel of switches located under an instrument guard. Release the left side of the panel from "Torpedo", pull assembly on yourself and disconnect an electrical wiring from switches. Try to remember an order of connection of contact sockets. Remove the panel.
6. Take an ashtray from the dashboard.
7. Turn out two lower fixing screws, having accurately hooked the small screw-driver, release clamps and remove facing of control panels of functioning of a radio tape recorder/heater.
8. Having hooked the small screw-driver, remove from the dashboard deflectors central ventilating nozzles. |
|
9. Turn out two fixing screws and take from the dashboard the casing snuffled. Disconnect an electrical wiring from the switches located in the central part of "Torpedo", hours and, at the corresponding complete set, a control lamp of the anticreeping alarm system / sensor of air temperature in interior of the car. |
|
|
10. From the back party of the panel release clamps and push out outside hours. |
|
