Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
- Repair of the engine
- The repair procedures which are not demanding extraction of the engine from the car - petrol engines
Check of compression pressure in cylinders
Fixing cranked / distributive shaft for the purpose of prevention of service of the car, casual in the course of performing procedures
Removal and installation of a cover of a head of cylinders
Removal and installation of a pulley of a bent shaft
Removal and installation of covers of a gas-distributing belt
GRM drive belt - the general information, removal and installation
Removal, check of a state and installation of a natyazhitel and cogwheels of a gas-distributing belt
Replacement of an epiploon(s) of the camshaft
Removal, check of a state and installation of the camshaft and pushers of valves
Check and adjustment of valvate gaps
Removal and installation of a head of cylinders
Removal and installation of the pallet of a case of the engine
Removal, check of a state and installation of the oil pump
Removal and installation of the oil cooler (model of 2.0 l)
Replacement of epiploons of a bent shaft
Removal, check of a state and installation of a flywheel / driving disk
Check of a state and replacement of support of a suspension bracket of the power unit
+ The repair procedures which are not demanding extraction of the engine from the car - diesel engines
+ Removal and capital repairs of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and finishing of salon
+ Onboard electric equipment
+ Schemes of electric equipment
|
Removal and installation of covers of a gas-distributing belt
Removal
L models 1.6 and 1.8
Top cover
|
|
|
1. Release clamps in the top part of a cover and release from them fuel hoses.
2. Turn out two fixing bolts in the basis of a cover and take the last from a motive compartment. |
|
Central cover
|
|
|
1. Turn out two fixing bolts located directly under a support arm.
2. Shift a cover up, for removal from the guides of pins located in the basis.
3. Take a cover from a motive compartment. |
|
Lower cover
|
|
|
1. Remove a pulley of a bent shaft (see Removal and installation of a pulley of a bent shaft).
2. Remove the central cover (see above).
3. Turn out two fixing bolts and remove the lower cover from the engine. Pay attention that on some models it is necessary to otboltit and remove previously assembly of a natyazhitel of an auxiliary driving belt. |
|
Models of 2.0 l
Top cover
|
|
|
1. Release clamps in the top part of a cover and release from them fuel hoses. |
|
2. Turn out two fixing bolts. |
|
|
3. Take a cover from a motive compartment, having pulled it up. |
|
|
Lower cover
|
|
|
1. Remove a pulley of a bent shaft (see Removal and installation of a pulley of a bent shaft). |
|
2. Turn out three fixing bolts and remove the lower cover of a gas-distributing belt from the engine. |
|
|
3. Pay attention that on some models it is necessary to otboltit and remove previously assembly of a natyazhitel of an auxiliary driving belt. |
|
|
Installation Installation is made as it should be, the return to a dismantle order. Track correctness of placement of covers and reliability of tightening of fixture (see Specifications).
|
On the homepage
|
