Citroën Xantia

since 1993 release

Repair and operation of the car



Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
- Running gear and steering
   Removal and installation of stupichny assembly of a forward suspension bracket
   Replacement of bearings of forward naves
   Removal, capital repairs and installation of the lower lever of a forward suspension bracket
   Removal and installation of the lower spherical support of a forward suspension bracket
   Removal and installation of components of the stabilizer of cross stability of a forward suspension bracket
   Removal and installation of assemblies of racks / hydraulic blocks of a forward suspension bracket
   Removal and installation of the proofreader of height of a road gleam of a forward suspension bracket
   Removal and installation of a stretcher of a forward suspension bracket
   Removal and installation of naves of back wheels
   Replacement of back stupichny bearings
   Removal and installation of longitudinal levers of a back suspension bracket
   Removal and installation of assembly of the back bridge
   Removal and installation of hydraulic blocks of a back suspension bracket
   Removal and installation of the proofreader of a road gleam of a back suspension bracket
   Check of installation and adjustment of a road gleam
   Removal and installation of a steering wheel
   Removal, check of a condition of components and installation of a steering column
   Removal and installation of assembly of the switch of the ignition/lock of a steering column
   The steering mechanism - general information, removal, capital repairs and installation
   System of hydrostrengthening of a wheel - general information
   Removal and installation of tips of steering drafts
   The angles of installation of wheels - the general information, check and adjustment of convergence of forward wheels
+ Body and finishing of salon
+ Onboard electric equipment
+ Schemes of electric equipment


04d84ca1



Removal and installation of the proofreader of height of a road gleam of a forward suspension bracket

Removal

At the corresponding complete set new sealing couplings of nipple sockets of hydraulic tubes will be required.


 PERFORMANCE ORDER

1. Dump pressure in hydraulic system (see the Head Uniform hydraulic system).
2. The car also establish to Poddomkratta it on props
3. Mark the adjusting provision of hydraulic tubes, then disconnect them from assembly of the proofreader of a road gleam. Get suitable drain capacity under assembly of the proofreader and disconnect hydraulic tubes. At once to a zakuporta the open ends of tubes and unions of their connection for the purpose of minimization of losses of liquid and in order to avoid hit in system of dirt.

4. Turn out bolts of fastening of the proofreader and release driving rods from the executive lever of assembly, remembering adjusting provisions of components. Take assembly of the proofreader from under the car.
1 — two hydraulic tubes
2 — fastening bolts

Installation

Recovery repair of the proofreader of height of a road gleam is not possible. In case of a device exit out of operation make replacement it assembled.

Installation is made upside-down. Pay attention to the next moments:
   a) Track correctness of connection and reliability of fastening of hydraulic tubes, at the corresponding complete set do not forget to replace sealing couplings of nipple sockets;
   b) Do not forget to grease spherical hinges of driving rods before connection them to the executive lever of the proofreader;
   c) After lowering of the car on the earth tighten spuskny the gate of the regulator of pressure and transfer a control lever a suspension bracket to situation "Maximum";
   d) Check the level of hydraulic liquid, in case of need make the corresponding adjustment (address the Head Routine maintenance);
   e) In conclusion check installation of a road gleam (see Check of installation and adjustment of a road gleam).


On the homepage