Citroën Xantia

since 1993 release

Repair and operation of the car



Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
- Running gear and steering
   Removal and installation of stupichny assembly of a forward suspension bracket
   Replacement of bearings of forward naves
   Removal, capital repairs and installation of the lower lever of a forward suspension bracket
   Removal and installation of the lower spherical support of a forward suspension bracket
   Removal and installation of components of the stabilizer of cross stability of a forward suspension bracket
   Removal and installation of assemblies of racks / hydraulic blocks of a forward suspension bracket
   Removal and installation of the proofreader of height of a road gleam of a forward suspension bracket
   Removal and installation of a stretcher of a forward suspension bracket
   Removal and installation of naves of back wheels
   Replacement of back stupichny bearings
   Removal and installation of longitudinal levers of a back suspension bracket
   Removal and installation of assembly of the back bridge
   Removal and installation of hydraulic blocks of a back suspension bracket
   Removal and installation of the proofreader of a road gleam of a back suspension bracket
   Check of installation and adjustment of a road gleam
   Removal and installation of a steering wheel
   Removal, check of a condition of components and installation of a steering column
   Removal and installation of assembly of the switch of the ignition/lock of a steering column
   The steering mechanism - general information, removal, capital repairs and installation
   System of hydrostrengthening of a wheel - general information
   Removal and installation of tips of steering drafts
   The angles of installation of wheels - the general information, check and adjustment of convergence of forward wheels
+ Body and finishing of salon
+ Onboard electric equipment
+ Schemes of electric equipment


04d84ca1



Check of installation and adjustment of a road gleam

Check

After each movement of a body and each measurement performed during the procedure described below the car it is necessary to roll away a little back and forth by rotation of one of driving wheels for the purpose of removal of tension arising in suspension bracket components.


 PERFORMANCE ORDER

1. Check pressure of a rating of tires, in case of need make the corresponding adjustment.
2. Lift the car on a platform.
3. Transfer a suspension bracket to "Normal" situation.
4. Release the parking brake.
5. Start the engine.
6. From below push the car with hands up, then release: the body has to shake down, then rise and be stabilized.
7. Determine height of a road gleam by a forward axis on both sides of the car for what measure distance between the plane of contact of wheels with a platform and the lower surface of a stretcher on the site passing along axes of power shafts. As control parameter arithmetic-mean value of two removed measurements undertakes.
8. Working in a similar manner, determine height of a road gleam by a back suspension bracket. In this case the distance from bearing platform plane to the lower surface of back rubber pillows of support of a suspension bracket is measured, then arithmetic-mean value of two removed measurements is calculated.
9. Compare results of check to requirements of Specifications.

Adjustment

Adjustment of a road gleam is made by means of special tools and its performance should be charged to specialists of car service.


On the homepage