Citroën Xantia

since 1993 release

Repair and operation of the car


Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
- Engine electric equipment
   - Systems of start and charge
      Diagnostics of malfunctions of electric equipment
      Check of a state and battery charging
      Removal and installation of the rechargeable battery
      Check of serviceability of functioning of system of a charge
      Removal, installation and adjustment of a tension of a belt of the drive of the generator
      Removal and installation of the generator
      Dismantling and assembly of the generator, check of a condition of internal components
      Check of serviceability of functioning of components of system of start
      Removal and installation of a starter
      Check of serviceability of functioning and repair of a starter
      Removal and installation of the switch of ignition
      Removal and installation of the sensor switch of a control lamp of pressure of oil
      Removal and installation of the sensor of level of motive oil
      Removal and installation of the sensor of temperature of motive oil
   + System of ignition - petrol models
   + System of preheat - diesel models
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and finishing of salon
+ Onboard electric equipment
+ Schemes of electric equipment

04d84ca1


Removal and installation of the generator

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Weaken a belt of the drive of auxiliary units (address the Head Routine maintenance) and throw off it from a generator pulley.

3. At the corresponding complete set remove protective rubber caps from generator plugs, then release terminal nuts and disconnect an electrical wiring from a back part of the generator.

4. Give a bolt/nut of fastening of the generator to the top basic arm. Pay attention that if for fastening of the generator the long through bolt is used, then there is no need for its full reversing: will be to weaken it only enough. On some models for the purpose of ensuring access to fixture of the generator it is necessary to remove an intermediate pulley / a tension roller of a driving belt.

5. On diesel models take clamps of fastening of the filter of a cover and remove the last for the purpose of ensuring access to the top fixing bolt.

6. Remove the generator from basic arms and take it from a motive compartment.

Installation

Installation is made upside-down. Track correctness of laying and adjustment of a tension of a driving belt (address the Head Routine maintenance). Make sure of reliability of tightening of fixture of the generator and its basic arms.


On the homepage