Citroën Xantia

1. The sensor switch is installed in a lobby of the block of cylinders, over a support of an oil filter. For the purpose of ensuring access to the sensor switch firmly cock the parking brake, then a front of the car and establish to a poddomkratta it on props.
2. Disconnect a negative wire from the battery.
3. At the corresponding complete set remove the protective coupling from the shtekerny socket, then disconnect an electrical wiring from the sensor switch.
4. Turn out the sensor switch from the block of cylinders and remove a sealing washer. Prepare for collecting the spilled oil. An opening at once to a zakuporta in order to avoid hit in the dirt engine.

1. Check a condition of a sealing washer. In case of detection of defects make replacement.
2. Screw the sensor switch with a washer on the regular place and tighten it with the required effort. Restore initial connection of an electrical wiring.
3. If lifted, lower the car on the earth, then check the level of motive oil. In case of need make the corresponding adjustment (address the Head Routine maintenance).