Citroën Xantia

since 1993 release

Repair and operation of the car

Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
- Engine electric equipment
   - Systems of start and charge
      Diagnostics of malfunctions of electric equipment
      Check of a state and battery charging
      Removal and installation of the rechargeable battery
      Check of serviceability of functioning of system of a charge
      Removal, installation and adjustment of a tension of a belt of the drive of the generator
      Removal and installation of the generator
      Dismantling and assembly of the generator, check of a condition of internal components
      Check of serviceability of functioning of components of system of start
      Removal and installation of a starter
      Check of serviceability of functioning and repair of a starter
      Removal and installation of the switch of ignition
      Removal and installation of the sensor switch of a control lamp of pressure of oil
      Removal and installation of the sensor of level of motive oil
      Removal and installation of the sensor of temperature of motive oil
   + System of ignition - petrol models
   + System of preheat - diesel models
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and finishing of salon
+ Onboard electric equipment
+ Schemes of electric equipment


Removal and installation of the sensor of temperature of motive oil


The sensor is screwed in a forward part of the pallet of a crater of the engine.


1. For the purpose of ensuring access to the sensor prop up antiretractable boots back wheels, then a front of the car and establish to a poddomkratta it on props.
2. Merge motive oil in pure capacity, screw into place a drain stopper and tighten it with the required effort (address the Head Routine maintenance).
3. Disconnect an electrical wiring, then turn out the sensor from the pallet of a case and remove together with a sealing washer.



1. Check a state ears, in case of need make replacement.
2. Screw the sensor on the regular place and carefully tighten. Connect an electrical wiring.
3. Lower the car on the earth and fill in engine oil in the engine (address the Head Routine maintenance).

On the homepage