Citroën Xantia

since 1993 release

Repair and operation of the car


Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
- Engine electric equipment
   - Systems of start and charge
      Diagnostics of malfunctions of electric equipment
      Check of a state and battery charging
      Removal and installation of the rechargeable battery
      Check of serviceability of functioning of system of a charge
      Removal, installation and adjustment of a tension of a belt of the drive of the generator
      Removal and installation of the generator
      Dismantling and assembly of the generator, check of a condition of internal components
      Check of serviceability of functioning of components of system of start
      Removal and installation of a starter
      Check of serviceability of functioning and repair of a starter
      Removal and installation of the switch of ignition
      Removal and installation of the sensor switch of a control lamp of pressure of oil
      Removal and installation of the sensor of level of motive oil
      Removal and installation of the sensor of temperature of motive oil
   + System of ignition - petrol models
   + System of preheat - diesel models
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and finishing of salon
+ Onboard electric equipment
+ Schemes of electric equipment

04d84ca1


Removal and installation of the rechargeable battery

The negative wire always has to be disconnected from the battery first of all, and be connected in the last!


If the car is completed with the audio system of a company complete set Citroyon before disconnecting the battery, make sure that you have the code necessary for shutdown of the lock of security system.

Removal

The battery is located in the left part of a motive compartment.

 PERFORMANCE ORDER

1. Release coupling bolts and remove a terminal clip from a negative pole of the battery.
2. Lift a protective cover (if that is provided) and disconnect a positive wire from the battery.

3. Turn out a bolt, take aside a clamping plate.

4. Remove the battery from the pallet and take it from a motive compartment. Turn out fixing bolts, release clamps of fastening of an electrical wiring and remove the battery pallet.
5. In case of need give fixing bolts and remove an assembly plate from the top part of the left support of the power unit.

Installation

Installation is made upside-down. At connection of wires to poles of the battery grease terminal knots with acid-free vaseline for the purpose of prevention of development of corrosion.



Always connect a negative wire in the last turn!



On the homepage