Citroën Xantia

since 1993 release

Repair and operation of the car



Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
- Brake system
   Pumping of hydraulic system
   Replacement of hoses and tubes of a hydraulic path of the brake system
   Replacement of blocks of disk brake mechanisms of forward wheels
   Replacement of blocks of disk brake mechanisms of back wheels
   Check of a state, removal and installation of brake disks
   Removal, capital repairs and installation of supports of disk brake mechanisms of forward wheels
   Removal, capital repairs and installation of supports of disk brake mechanisms of back wheels
   Removal, capital repairs and installation of the valve of management
   Removal and installation of a pedal of a foot brake
   The parking brake - general information and adjustments
   Removal and installation of a control lever of the parking brake
   Removal and installation of cables of the drive of the parking brake
   Removal and installation of the sensor switch of stoplights
   System of anti-blocking of brakes (ABS) - the general information
   Removal and installation of components of system of anti-blocking of brakes
+ Running gear and steering
+ Body and finishing of salon
+ Onboard electric equipment
+ Schemes of electric equipment


04d84ca1



Removal and installation of a pedal of a foot brake

Removal

 PERFORMANCE ORDER

1. Remove assembly of the dashboard (address the Head Kuzov and finishing of salon).
2. Where it is required remove an air duct of system of heating of salon for the purpose of ensuring access.
3. In the top part of a basic arm of a steering column block an axial bolt of a pedal of a foot brake from a provorachivaniye and give a nut of its fastening.
4. Carefully unhook a returnable spring. Try to remember an order of installation of a spring on pedal assembly. Remove a pedal from a basic arm.
5. Disconnect an electrical wiring from the sensor switch of stoplights and take a pedal from the car.

Installation

Installation is made upside-down. Track correctness of connection of a returnable spring. Do not forget to install into place the dashboard (address the Head Kuzov and finishing of salon).


On the homepage