Citroën Xantia

since 1993 release

Repair and operation of the car



Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
- Brake system
   Pumping of hydraulic system
   Replacement of hoses and tubes of a hydraulic path of the brake system
   Replacement of blocks of disk brake mechanisms of forward wheels
   Replacement of blocks of disk brake mechanisms of back wheels
   Check of a state, removal and installation of brake disks
   Removal, capital repairs and installation of supports of disk brake mechanisms of forward wheels
   Removal, capital repairs and installation of supports of disk brake mechanisms of back wheels
   Removal, capital repairs and installation of the valve of management
   Removal and installation of a pedal of a foot brake
   The parking brake - general information and adjustments
   Removal and installation of a control lever of the parking brake
   Removal and installation of cables of the drive of the parking brake
   Removal and installation of the sensor switch of stoplights
   System of anti-blocking of brakes (ABS) - the general information
   Removal and installation of components of system of anti-blocking of brakes
+ Running gear and steering
+ Body and finishing of salon
+ Onboard electric equipment
+ Schemes of electric equipment


04d84ca1



Removal and installation of the sensor switch of stoplights

Removal

 PERFORMANCE ORDER

1. The sensor switch is built in a rubber emphasis of a pedal of a foot brake.
2. Disconnect a negative wire from the battery.
3. Release fixing clamps and remove the lower section of finishing of the dashboard in a driver's foot well.
4. In the top part of a pedal disunite the socket of an electrical wiring of the sensor switch of stoplights.
5. Release an electrical wiring from a pedal.

6. Under a pedal, give a fixing nut and remove assembly of a rubber emphasis with the sensor switch which is built in in it.

Installation

Installation is made upside-down. Track reliability of fixing of an electrical wiring on pedal assembly.


On the homepage