Citroën Xantia

since 1993 release

Repair and operation of the car



Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
- Brake system
   Pumping of hydraulic system
   Replacement of hoses and tubes of a hydraulic path of the brake system
   Replacement of blocks of disk brake mechanisms of forward wheels
   Replacement of blocks of disk brake mechanisms of back wheels
   Check of a state, removal and installation of brake disks
   Removal, capital repairs and installation of supports of disk brake mechanisms of forward wheels
   Removal, capital repairs and installation of supports of disk brake mechanisms of back wheels
   Removal, capital repairs and installation of the valve of management
   Removal and installation of a pedal of a foot brake
   The parking brake - general information and adjustments
   Removal and installation of a control lever of the parking brake
   Removal and installation of cables of the drive of the parking brake
   Removal and installation of the sensor switch of stoplights
   System of anti-blocking of brakes (ABS) - the general information
   Removal and installation of components of system of anti-blocking of brakes
+ Running gear and steering
+ Body and finishing of salon
+ Onboard electric equipment
+ Schemes of electric equipment


04d84ca1



Removal and installation of a control lever of the parking brake

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Remove the central console (address the Head Kuzov and finishing of salon).

3. At the corresponding complete set release the control unit of the uniform lock from the bearing arm on a floor of salon. On the models equipped with natyazhitel of seat belts shift an arm for the purpose of ensuring access to nuts of fastening of a control lever of the parking brake aside, - try not to allow tensions of an electrical wiring of the control unit of natyazhitel.

4. Disconnect driving cables of the parking brake from supports of brake mechanisms (see Removal and installation of cables of the drive of the parking brake).
5. Release from an arm behind assembly of a control lever the sensor switch of a control lamp of raising of the parking brake, disconnect the corresponding electrical wiring.

6. Disconnect primary cable of the drive of the parking brake from a control lever.

7. Give three fixing nuts and remove assembly of a control lever of the parking brake.

Installation

Installation is made upside-down. Having finished installation of the lever, check adjustment of the drive of the parking brake (see. The parking brake - general information and adjustments).


On the homepage