Citroën Xantia

since 1993 release

Repair and operation of the car

Citroën Xantia
+ Introduction
+ Operation manual
- Routine maintenance
   + Weekly checks
   + Routine maintenance of the car - petrol models
   - Routine maintenance of the car - diesel models
      Regular service
      Replacement of motive oil and oil filter
      Check of a condition of hoses, and identification of sources of leaks
      Removal of water from the fuel filter
      Coupling adjustment check
      Check of the ATF level
      Suspension bracket and drive of steering
      Check of a condition of protective covers of power shafts
      Reading of memory of the block of self-diagnostics
      Replacement of the dust removal filter (model with To/in)
      Check of a condition of coolant of the air conditioning system
      Check and adjustment of turns of idling and prevention of a spontaneous stop of the engine
      Check of serviceability of functioning of systems of decrease in toxicity of the fulfilled gases
      Check of a state and replacement of a belt of the drive of auxiliary units
      Greasing of the mechanism of the drive of switching off of coupling
      Check of serviceability of functioning and adjustment of the parking brake
      Trial runs
      Replacement of the fuel filter
      Replacement of the AT transmission liquid
      Check of a condition of blocks of brake mechanisms of forward and back wheels
      Greasing of locks and loops
      Replacement of hydraulic LHM liquid and returnable filter
      Replacement of the filtering air cleaner element
      Check of level of gearbox oil (model with RKPP)
      Check of a condition of brake supports, disks and hydraulic hoses
      Replacement of a belt of the GRM drive
      Replacement of cooling liquid
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and finishing of salon
+ Onboard electric equipment
+ Schemes of electric equipment

Replacement of the filtering air cleaner element

THROUGH EACH 60 000 KM (36 000 MILES) OF THE RUN

PERFORMANCE ORDER

1. Release fixing clamps and uncover the air cleaner. Do not disconnect an air sleeve from the inlet pipeline.
2. Take the filtering element from the air cleaner case.
3. Enclose the replaceable filtering element in the lower part of the case of the air cleaner. Establish into place a cover and latch clamps of its fastening.

On the homepage