Citroën Xantia

since 1993 release

Repair and operation of the car

Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
- Power supply system and release
   - A power supply system - petrol models
      Removal and installation of assembly of the air cleaner
      Removal, installation and adjustment of a cable of gas
      Removal and installation of the accelerator pedal
      Unleaded fuel - the general information and rules of use
      Systems of injection of fuel - the general information
      Dropping pressure in a power supply system
      Removal and installation of the fuel pump
      Removal and installation of the sensor of fuel consumption
      Removal and installation of the fuel tank
      Check of a state and adjustment of system of injection of fuel
      Removal and installation of the case of a throttle
      Removal and installation of components of the Bosch Motronic 5.1 system
      Removal and installation of components of the Magneti-Marelli 8P system
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
   + A power supply system - diesel models
   + Systems of decrease in toxicity and production of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and finishing of salon
+ Onboard electric equipment
+ Schemes of electric equipment

Removal and installation of the accelerator pedal

Removal

PERFORMANCE ORDER

1. Disconnect a pedal gas cable (see Removal, installation and adjustment of a cable of gas).
2. Remove a lock ring from one of the ends of an axis of the accelerator pedal.
3. Take an axis and remove a pedal from an arm assembled with axial plugs.
4. Check a condition of plugs and an axis, replace defective components.

Installation

Installation is made upside-down. Axial assembly should be greased with universal lubricant previously. In conclusion make adjustment of a cable of gas (see Removal, installation and adjustment of a cable of gas).

On the homepage