Citroën Xantia

since 1993 release

Repair and operation of the car



Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
- Power supply system and release
   - A power supply system - petrol models
      Removal and installation of assembly of the air cleaner
      Removal, installation and adjustment of a cable of gas
      Removal and installation of the accelerator pedal
      Unleaded fuel - the general information and rules of use
      Systems of injection of fuel - the general information
      Dropping pressure in a power supply system
      Removal and installation of the fuel pump
      Removal and installation of the sensor of fuel consumption
      Removal and installation of the fuel tank
      Check of a state and adjustment of system of injection of fuel
      Removal and installation of the case of a throttle
      Removal and installation of components of the Bosch Motronic 5.1 system
      Removal and installation of components of the Magneti-Marelli 8P system
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
   + A power supply system - diesel models
   + Systems of decrease in toxicity and production of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and finishing of salon
+ Onboard electric equipment
+ Schemes of electric equipment


e94432e4



Removal and installation of assembly of the air cleaner

Removal

 PERFORMANCE ORDER

1. Weaken a collar(s) and disconnect a ventilating hose(s) from the air sleeve connecting the air cleaner to the throttle case. Afterwards release fixing collars, disconnect an air sleeve from the air cleaner and remove it from the car. Where it is required, remove a rubber sealing ring from the throttle case.
2. Release two clamps, turn out two screws in a forward part of a cover of a head of cylinders and uncover the air cleaner a head of cylinders. Take the filtering element.
3. For removal of an inlet air duct give a bolt of fastening of its back section to an end face of a head of cylinders, then weaken a fixing collar and disconnect a sleeve from a cover of a head of cylinders. Turn out a bolt of fastening of forward section of an air duct to a cross beam and take a sleeve from a motive compartment.

Installation

Installation is made upside-down. Track correctness of connection and reliability of fastening of all hoses and sleeves.

On the homepage