Citroën Xantia

since 1993 release

Repair and operation of the car



Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
- Repair of the engine
   + The repair procedures which are not demanding extraction of the engine from the car - petrol engines
   - The repair procedures which are not demanding extraction of the engine from the car - diesel engines
      Measurement of compression pressure and check of the engine on tightness
      Fixing cranked / distributive shaft and TNVD for the purpose of prevention of casual hit of valves in contact with pistons in the course of performing procedures of service of the car
      Removal and installation of a cover of a head of cylinders
      Removal and installation of a pulley of a bent shaft
      Removal and installation of covers of a gas-distributing belt
      GRM drive belt - the general information, removal, check of a state and installation
      Removal and installation of cogwheels of a belt of the GRM drive
      Removal and installation of components of the right support of the power unit and natyazhitel of a gas-distributing belt
      Removal and installation of an intermediate roller of a gas-distributing belt
      Removal, check of a state and installation of the camshaft and pushers of valves
      Check and adjustment of valvate gaps
      Removal and installation of a head of cylinders
      Removal and installation of the pallet of a case
      Removal, check of a state and installation of the oil pump with a driving chain
      Replacement of epiploons
      Sensors of level, pressure and temperature of motive oil - the general information
      Removal, check of a state and installation of a flywheel / driving disk
      Check of a state and replacement of support of a suspension bracket of the power unit
      Removal and installation of the oil cooler
   + Removal and capital repairs of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and finishing of salon
+ Onboard electric equipment
+ Schemes of electric equipment


04d84ca1



Removal and installation of a cover of a head of cylinders

Removal

 PERFORMANCE ORDER

1. Remove a distributive casing (see the Power supply system - diesel models).
2. Release disconnect a ventilating hose from a forward wall of a cover of a head of cylinders. Where it is required, disconnect also air sleeve from the inlet pipeline.

3. Turn out a fixing bolt and remove an arm of fixing of a fuel hose from the right wall of a cover of a head of cylinders.

4. Remembering the correct arrangement of arms and clamps, turn out three bolts of fastening of a cover of a head of cylinders, and remove them together with metal and fiber glass washers.

5. Shift the hoses interfering with removal all covers aside.

6. Uncover a head of cylinders and take rubber sealing laying. Check laying for existence of damages and signs of aging of material, in case of need make replacement.

Installation

Installation is made upside-down. Pay attention to the next moments:
  a) Track correctness of installation of all arms and clamps;
  b) Establish a distributive casing according to the instructions provided in the section Power supply system - diesel models.


On the homepage