Citroën Xantia

since 1993 release

Repair and operation of the car



Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
- Cooling systems, heating
   Detachment and replacement of hoses of the cooling system
   Removal, check of a state and installation of a radiator
   Removal, check of serviceability of functioning and installation of the thermostat
   Check of serviceability of functioning, removal and installation of the fan(s) of the cooling system
   Check of serviceability of functioning, removal and installation of electric switches and sensors of the cooling system
   Removal and installation of the water pump
   Removal and installation of a casing of the thermostat / fuel filter (diesel models)
   System of heating/ventilation of salon - the general information
   Removal and installation of components of system of heating/ventilation of salon
   The air conditioning system - the general information and precautionary measures
   Removal and installation of components of the air conditioning system
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and finishing of salon
+ Onboard electric equipment
+ Schemes of electric equipment


e94432e4



Removal and installation of the water pump

Removal

 PERFORMANCE ORDER

1. The drive of the water pump is carried out by a gas-distributing belt. The pump приболчен to the block of cylinders from the GRM drive.
2. Empty the cooling system (address the Head Routine maintenance).
3. Take off a GRM drive belt (see the Head Remont of the engine).

4. Turn out fixing bolts and take assembly of the pump from the block of cylinders (optimum access opens through a wheel arch). Remove sealing laying.



Installation

 PERFORMANCE ORDER

1. Make sure of absoluteness of purity and dryness of the interfaced surfaces of the pump and block of cylinders.
2. Install the pump on the regular place (do not forget to replace laying).
3. Establish a GRM drive belt (see appropriate section of the Head Remont of the engine).
4. Fill the cooling system (address the Head Routine maintenance).


On the homepage