Citroën Xantia

since 1993 release

Repair and operation of the car



Citroën Xantia
+ Introduction
+ Operation manual
- Routine maintenance
   + Weekly checks
   - Routine maintenance of the car - petrol models
      Regular service
      Replacement of motive oil and oil filter
      Check of a condition of hoses, and identification of sources of leaks
      Coupling adjustment check
      Check of the ATF level
      Suspension bracket and drive of steering
      Check of a condition of protective covers of power shafts
      Reading of memory of the block of self-diagnostics
      Replacement of the dust removal filter (model with To/in)
      Check of a condition of coolant of the air conditioning system
      Replacement of spark plugs
      Check of a condition of system of ignition
      Check and adjustment of turns and quality of mix of idling
      Check of serviceability of functioning of systems of decrease in toxicity of the fulfilled gases
      Check of a state and replacement of a belt of the drive of auxiliary units
      Greasing of the mechanism of the drive of switching off of coupling
      Check of a condition of blocks of brake mechanisms of forward and back wheels
      Check of serviceability of functioning and adjustment of the parking brake
      Trial runs
      Replacement of the AT transmission liquid
      Greasing of locks and loops
      Replacement of the filtering air cleaner element
      Check of level of gearbox oil (model with RKPP)
      Replacement of the fuel filter
      Replacement of hydraulic LHM liquid and returnable filter
      Check of a condition of brake supports, disks and hydraulic hoses
      Replacement of a belt of the GRM drive
      Replacement of cooling liquid
   + Routine maintenance of the car - diesel models
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and finishing of salon
+ Onboard electric equipment
+ Schemes of electric equipment


04d84ca1



Replacement of hydraulic LHM liquid and returnable filter

THROUGH EACH 60 000 KM (36 000 MILES) OF THE RUN

In hydraulic systems of the cars of the Citroyon Xantia brand equipped with an active suspension bracket special mineral hydraulic LHM liquid of dark green color is used. Use of liquid of any other type is fraught with failure of rubber hoses and sealing cuffs of system. You store a reserve of hydraulic liquid in hermetically closed container.


 PERFORMANCE ORDER

1. Remove and empty in drain capacity the tank of hydraulic liquid (see the Head Uniform hydraulic system).
2. Also merge liquid from a hose of the high pressure connecting the central section of the tank to the hydraulic pump.

3. Release a clamp of fastening of two filters from below to the central section of the tank.

4. Take the rectangular filter from the central section of the tank.

5. Then develop as appropriate and take the round filter.

6. Wash out filters and the tank pure gasoline. Dry components, having ideally blown them compressed air.

When using compressed air do not forget to put on goggles!

7. Install the washed-out filters on the regular place in the central section of the tank, then install the tank (see the Head Uniform hydraulic system).
8. Fill in fresh hydraulic LHM liquid in the tank.
9. Fill with liquid of a cavity of a hydraulic contour (see the Head Uniform hydraulic system).
10. In conclusion check liquid level, in case of need make the corresponding adjustment (see. Weekly checks).



On the homepage