Citroën Xantia

since 1993 release

Repair and operation of the car


Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
- Power shafts
   Removal and installation of power shafts
   Replacement of rubber protective covers of CV JOINTS of power shafts
   Capital repairs of power shafts - the general information
   Replacement of the intermediate bearing of the right power shaft
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and finishing of salon
+ Onboard electric equipment
+ Schemes of electric equipment

04d84ca1


Replacement of the intermediate bearing of the right power shaft

The stripper with long guides will be required.


 PERFORMANCE ORDER

1. Remove assembly of the right power shaft (see Removal and installation of power shafts).
2. Check freedom of rotation of an external holder of the bearing (the mutual side play between holders has to remain uniform). In case of need make replacement of the bearing (see further).

3. By means of a special universal stripper with long guides accurately remove assembly of the intermediate bearing with the landing plug from internal section of a shaft. Slightly grease with dense lubricant an internal holder of the new bearing and put it on a shaft pin. Striking blows with the hammer to an internal holder through the drift made of a piece of a pipe of suitable diameter, put assembly of the bearing on a shaft against the stop it in external section of the CV JOINT. Afterwards put the plug, having densely pressed it to an internal holder of the bearing.

4. Check freedom of rotation of the bearing, then install assembly of a power shaft on the car (see Removal and installation of power shafts).



On the homepage